NEC-LIST: Re: Conical Spiral Impedance Convergence

Quoting nec-list-request_at_robomod.net:

Concerning my previous e-mail I should also
point out that the "Average gain test" returns
"Bad model".

Reducing the radius of all conductors to 1 mm clears
all the problem areas. The "Average gain test"
returns "Very good".

While your model is probably over segmented, it does
not appear to violate any NEC criteria.

Incidentally; in NEC 4 the geometry command set
reduces to three lines of code.

Regards,

Frank Meredith

-- 
The NEC-List mailing list
NEC-List_at_robomod.net
http://www.robomod.net/mailman/listinfo/nec-list