NEC-LIST: horizontal quad loop - matching problem

(long lines)

The following appeared on a technical news group and I too would like an answer to this problem.
Can anyone help?

Yesterday I erected a horizontal quad loop for 160 between 4 wooden poles 10m up.
It works OK on 160 and 80 TX and RX on all HF bands. No problem with a ATU on the higher bands.
I used this very same antenna many years ago in ZS3 (now V51) with great success, BUT, it
worked on ALL HF bands with low SWR (we then called it a German Quad).
I cannot recall what I did differently then and lost the original 73 Magazine article with all the specs, etc.
Current setup: feeding it with 50ohm coax to a 1:1 balun (yes I know the match is not
perfect but this is the very same balun I used way back).
I vaguely remember something of a step ladder at the opposite end of the cubica. Ideally I would
like to use a 2:1 or 3:1 balun. I don't want to use an ATU.

Any help, ideas and advice?

Chris Turner IEng MIIE
G4HKP
Tel: +44 1844 238502
Mob: +44 7812 174133

-- 
The NEC-List mailing list <nec-list_at_gweep.ca>
http://www.gweep.ca/mailman/listinfo.cgi/nec-list