Use an exclamation point at the beginning of the line you want to comment
out.
John Yorko
-----Original Message-----
From: Steve Inge [mailto:sringe_at_actrix.gen.nz]
Sent: Monday, June 17, 2002 3:08 AM
To: bdewitt_at_ix.netcom.com
Cc: NEC List
Subject: Re: NEC-LIST:comments and sub-sections
The only method that I know works, is to move the unwanted
cards to
after the EN card. Depending on what you want to achieve,
you could
put a GE, followed by an EN card.
Brent DeWitt wrote:
>
> Is there a way to "comment out" sections of a NEC2
geometery input file?
> I've tried moving the GE card up, but I get an error on
the first GW card
> after it and that aborts the run. It also seems that
CM/CE cards aren't
> allowed after the first geometry card.
>
> Any help would be appreciated!
>
> Brent DeWitt
> --
> The NEC-List mailing list <nec-list_at_gweep.ca>
> http://www.gweep.ca/mailman/listinfo.cgi/nec-list
--
sringe_at_actrix.gen.nz,
Steve.Inge_at_ieee.org-------------------------------
Steve Inge, ZL2BDV, RF Engineering Analyst. Island Bay,
Wellington, New
Zealand.
Phone +64 4 3838 422, Fax: +64 4 3838 691. Mobile +64 25
463 330.
--
The NEC-List mailing list <nec-list_at_gweep.ca>
http://www.gweep.ca/mailman/listinfo.cgi/nec-list
************************************
If this email is not intended for you, or you are not responsible for the
delivery of this message to the addressee, please note that this message may
contain ITT Privileged/Proprietary Information. In such a case, you may not
copy or deliver this message to anyone. You should destroy this message and
kindly notify the sender by reply email. Information contained in this
message that does not relate to the business of ITT is neither endorsed by
nor attributable to ITT.
************************************
-- The NEC-List mailing list <nec-list_at_gweep.ca> http://www.gweep.ca/mailman/listinfo.cgi/nec-listReceived on Tue Jun 18 2002 - 15:09:49 EDT
This archive was generated by hypermail 2.2.0 : Sat Oct 02 2010 - 00:10:42 EDT