NEC-LIST: Wire connection to patches

My previous comments were incorrect. The problem I had with anomalous wire currents were caused
by the length of wire segments as compared to the dimension of the patch to which the last segment was connected.
On further investigation, I get nonsensical answers (large errors over a large range of lower-frequencies)
when the wire segment length is less than 60% of the patch dimension. Keeping the segment as long as the patch
dimension appears safest. The program does divide the patch into four sub-patches when the wire is attached
in the middle, even for the Muliple Patch (SM) option.

-- 
The NEC-List mailing list
NEC-List_at_robomod.net
http://www.robomod.net/mailman/listinfo/nec-list