NEC-LIST:helical ant. modeling

From: Cornel Gazdaru <cornel_gazdaru_at_email.domain.hidden>
Date: Wed, 03 Oct 2001 23:07:09 -0400

Hello ,

I try to model a helical antenna, made of a printed line on a flexible
substrate that then I roll onto a cylinder.
Does anybody know of an equivalency "printed line width" - "wire
diameter", so I can accurately obtain some impedance information?

Thank you,
Cornel Gazdaru

-- 
The NEC-List mailing list <nec-list_at_gweep.ca>
http://www.gweep.ca/mailman/listinfo.cgi/nec-list

Received on Thu Oct 04 2001 - 00:01:06 EDT

This message: [ Message body ]
Next message: Trevor Marshall: "Re: NEC-LIST:helical ant. modeling"
Previous message: Roy Lewallen: "Re: NEC-LIST:NEC model for coaxial collinear ( COCO antenna)"
Next in thread: Trevor Marshall: "Re: NEC-LIST:helical ant. modeling"
Reply: Trevor Marshall: "Re: NEC-LIST:helical ant. modeling"
Reply: Steven Best: "RE: NEC-LIST:helical ant. modeling"
Maybe reply: Ian Roberts: "RE: NEC-LIST:helical ant. modeling"
Maybe reply: Ian Roberts: "RE: NEC-LIST:helical ant. modeling"
Maybe reply: John Thompson: "RE: NEC-LIST:helical ant. modeling"

Contemporary messages sorted: [ by date ] [ by thread ] [ by subject ] [ by author ] [ by messages with attachments ]

This archive was generated by hypermail 2.2.0 : Sat Oct 02 2010 - 00:10:41 EDT