Good day Nicolaos,
This is a follow-up to Chuck's reply. For distributed
conductivity, the LD command should read
LD 5 0 0 0 X 1
where X is the conductivity of the material in S/m (mho/m,
1/(resistivity in ohm-m)).
To get the currents, use the PT command. PT 0 will give you segment
centers and lengths, and currents in all segments. If you only want
certain segments, you can specify them with additional entries in the
PT command.
Doug Miron
Received on Mon Jun 05 2000 - 18:21:53 EDT
This archive was generated by hypermail 2.2.0 : Sat Oct 02 2010 - 00:10:40 EDT